Guidelines For Clean Working Conditions
WARNING: This page is about a different variant/trim than selected.
- Always clean the connection locations and the area around them before loosening.
- Clean the transmission and transmission components using Cleaning Solution D 009 401 04.
- Use lint-free cloths when cleaning. Audi recommends the "WYPALL X70/WORKHORSE" cloth made by Kimberly-Clark Professional.
- Seal all open lines and connections immediately with clean plugs or caps from the Engine Bung Set VAS6122.
- Place removed parts on a clean surface and cover them. Use foil or lint-free cloths.
- Cover or plug unpacked components if repairs cannot be performed immediately.
- Only install clean components: Install replacement parts immediately after removing them from their packaging.
- Protect the disconnected connectors from dirt and moisture and only connect when they are dry.