Right Flange Shaft, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Pressing Circlip With New Circlip Out Of Flanged Shaft Groove

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

NOTE:

Replace the circlip on the right flange shaft.

-- Clamp the flange shaft in a vise with jaw protectors. Remove the old circlip from the groove in the flange shaft using the new circlip -A-.

-- Drive in the right flange shaft using the Bearing/Bushing Installer - Multiple Use VW295.

-- Install the right drive axle. Refer to OVERVIEW - DRIVE AXLE .

-- Install the driveshaft heat shield. Refer to Fig 2.

Fig 2: Drive Axle Heat Shield & Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Gear oil level in front final drive, checking and filling, refer to GEAR OIL, CHECKING LEVEL, FRONT FINAL DRIVE .