Windshield Wiper/Washer Switch -E22-, REMOVING AND INSTALLING

Removal

-- Remove the steering column switch module, refer to STEERING COLUMN SWITCH MODULE, REMOVING AND INSTALLING .

NOTE:

Steering must be in center position (wheels in straight ahead position) when Removing and Installing coil connector with slip ring.

-- Carefully release catches in direction of -arrows-.

-- Remove airbag spring/spiral spring with slip ring -2- with Steering Angle Sensor -G85- item -1- from steering column switch module.

Fig 1: Identifying Catches, Slip Ring, And Steering Angle Sensor G85

Courtesy of AUDI OF AMERICA, LLC

-- Remove screws -1- and -2- and remove Windshield Wiper/Washer Switch -E22- item -3- from steering column switch module in direction of -arrow-.

Fig 2: Identifying Screws And Windshield Wiper/Washer Switch

Courtesy of AUDI OF AMERICA, LLC

Installation

Install in reverse order of removal. Note the following:

-- Make sure all fasteners and electrical connectors are properly engaged.

-- Install the steering column switch module, refer to STEERING COLUMN SWITCH MODULE, REMOVING AND INSTALLING .