Steering Column Electronic Control Module -J527-, REMOVING AND INSTALLING

-- If the control module was replaced, select the "Replace" function for the respective control module in "Guided Fault Finding" or "Guided Functions" Vehicle Diagnostic Tester.

Removal

-- Remove the steering column switch module, refer to STEERING COLUMN SWITCH MODULE, REMOVING AND INSTALLING .

NOTE:

Steering must be in center position (wheels in straight ahead position) when Removing and Installing coil connector with slip ring.

-- Carefully release catches in direction of -arrows-.

Fig 1: Identifying Catches, Slip Ring, And Steering Angle Sensor G85

Courtesy of AUDI OF AMERICA, LLC

-- Remove airbag spring/spiral spring with slip ring -2- with Steering Angle Sensor -G85- item -1- from steering column switch module.

-- Remove screws -arrows- and remove Steering Column Electronic Systems Control Module -J527- item -1- from steering column switch module.

Fig 2: Identifying Screws And Steering Column Electronics Systems Control Module J527 From Steering Column Switch Module

Courtesy of AUDI OF AMERICA, LLC

Installation

Tightening specifications, refer to STEERING COLUMN SWITCH MODULE OVERVIEW .

Install in reverse order of removal. Note the following:

-- Make sure all fasteners and electrical connectors are properly engaged.

-- Install the steering column switch module, refer to STEERING COLUMN SWITCH MODULE, REMOVING AND INSTALLING .

Code the Steering Column Electronic Control Module -J527- with the Vehicle Diagnostic Tester if is was replaced.