Working On Reducing Agent Metering System, Vehicles With SCR Catalytic Converter: Notes
WARNING: This page is about a different variant/trim than selected.
Observe the following when working on the reducing agent metering system:
WARNING:
The reducing agent can cause skin irritation.
- Avoid contact with skin and eyes! Wear protective gloves!
- If reducing agent should get on your skin, wash it off immediately with soap and water.
- If reducing agent gets in your eye, rinse the eye for several minutes with water.
- Never inhale or swallow the reducing agent!
- Should you swallow any reducing agent, rinse your mouth, drink plenty of water and contact a doctor immediately.
Note the following when Removal or Installation any components of the reducing agent metering system:
- The reducing agent active/passive tanks must be empty when working on the reducing agent metering system. Be sure to read the work procedure whenever the reducing agent in the active or passive tank must be emptied. Drain the active tank or the passive tank, if necessary. For information on the active tank, refer to REDUCING AGENT ACTIVE TANK, DRAINING and for the passive tank, refer to REDUCING AGENT PASSIVE TANK, DRAINING .
Note the following when Removing and Installing the active or passive tank:
- The reducing agent active/passive tank must be empty. Drain the active or passive tank, if necessary. For information on the active tank, refer to REDUCING AGENT ACTIVE TANK, DRAINING and for the passive tank, refer to REDUCING AGENT PASSIVE TANK, DRAINING .