Oil Pan Upper Section, Removing And Installing: Removal
WARNING: This page is about a different variant/trim than selected.
- The engine is secured to the Engine and Transmission Holder. Refer to ENGINE, SECURING ON ENGINE AND TRANSMISSION HOLDER .
- Engine oil is drained. Refer to Maintenance Booklet 406.
-- Remove the timing chain cover lower section. Refer to LOWER TIMING CHAIN COVER, REMOVING AND INSTALLING .
-- Remove the power take-off drive chain. Refer to POWER TAKE-OFF DRIVE CHAIN, REMOVING AND INSTALLING .
-- Remove the belt pulley side sealing flange. Refer to SEALING FLANGE, BELT PULLEY SIDE, REMOVING AND INSTALLING .
-- Remove the oil pump. Refer to OIL PUMP, REMOVING AND INSTALLING .
-- Remove the bolts -1 to 4-.
-- Carefully loosen the oil pan upper section from the bond and press it off the cylinder block alignment bushings.