Charge Air Cooler, Removing And Installing: Installation
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal. Note the following:
- Tightening specifications. Refer to CHARGE AIR COOLER OVERVIEW .
NOTE:
If there are small impressions on the fins. Refer to COOLERS, CONDENSERS AND CHARGE AIR COOLERS, INSTALLATION .
The hose connections as well as the air guide pipes and hoses must be free of oil and grease before Installation.
Secure all hose connections with hose clamps of the same type as those equipped by the factory.
-- Install the air duct pipes with the connector coupling, refer to Figure.
-- Install the front bumper cover. Refer to FRONT BUMPER, REMOVING AND INSTALLING .
-- Install the noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .
-- On a vehicle with air suspension, deactivate vehicle lift mode. Refer to VEHICLE LIFT MODE .