Engine Mount, Removing And Installing: Installation
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal. Note the following:
- Tightening specifications. Refer to SUBFRAME OVERVIEW .
NOTE:
The hose connections as well as the air guide pipes and hoses must be free of oil and grease before Installation.
Secure all hose connections with hose clamps of the same type as those equipped by the factory.
-- Install the refrigerant lines. Refer to COMPRESSOR REFRIGERANT LINES, DISCONNECTING AND CONNECTING .
-- Install the wheel housing liner. Refer to Wheel Housing Liners .
-- Install the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .
-- Install the air duct hose and screw-type clamps, refer to Fig 1.
-- Install the ribbed belt tensioner. Refer to RIBBED BELT TENSIONER, REMOVING AND INSTALLING .