Drive Plate, Removing And Installing

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

Removal

Fig 1: Inserting Counter Hold Tool 10-201

Courtesy of AUDI OF AMERICA, LLC

-- Insert the Counterhold - Flywheel10-201 to loosen the bolts.

-- Remove the bolts and then remove the washer, the driveplate and the shim behind them.

-- Vehicles built from 06.10: remove the sensor wheel from the Engine Speed Sensor -G28-.

Installation

Install in reverse order of removal. Note the following:

NOTE:

Replace the drive plate bolts.

-- Vehicles built through 05.10: place a 1.5 mm shim on the crankshaft.

-- Be careful of the alignment bushings when Installation the other parts.

-- Position Counterhold - Flywheel10-201 to tighten the bolts.