Transfer Fuel Pump - G6-, REMOVING AND INSTALLING, VEHICLES WITH 6.0L (V12) ENGINE: Installing

Install in reverse order of removal. Note the following:

• Tightening specifications, refer to OVERVIEW - FUEL DELIVERY UNIT/SUCTION JET PUMP/FUEL LEVEL SENSOR, VEHICLES WITH 6.0L (V12) ENGINE .

-- Install the fuel delivery unit into the fuel tank.

• The notch -2- on the fuel delivery unit then aligns with the tab -1- on the retaining ring.
• It must be possible to push the fuel delivery unit downward.

-- Turn the fuel delivery unit -3- 15°-clockwise -arrow- to secure it (bayonet connection).

-- Push the suction jet pipe -1- onto the suction jet pump until it clicks into place.

-- Push the supply line -3- onto the fuel delivery unit until it clicks into place.

-- Attach the fuel line -2- to the left fuel delivery unit until it clicks into place.

-- Attach the supply line -1- to the auxiliary heater on the fuel delivery unit -arrow- until it clicks.

-- Push the fuel lines -2- and -3- onto the right locking flange until they click into place.

-- Disconnect the connector -1- from the fuel pump on the bottom side of the right locking flange.

-- Wrap the wire -2- for the Fuel Level Sensor -G- twice around the wire -1- for the fuel pump and then connect it to the right locking flange.

-- Install the new seal for the right locking flange dry.

-- Bring the right locking flange into the installation position.

• Tab -2- on right locking flange faces toward arrow marking and must lie between tabs -1- and -3- on fuel tank.

-- Install the right locking flange cover Figure.

-- Insert the frame into the floor covering, refer to Interior Trim .

-- Install the right rear single seat in the second row of seats, refer to Seat Frames .

-- Vehicles with parking heater: Bleed the fuel supply line to the metering pump, refer to FUEL SUPPLY LINE TO METERING PUMP, BLEEDING, VEHICLES WITH PARKING HEATER .

-- After installing fuel delivery unit, fill vehicle with at least 5 liters of fuel.