Accelerator Pedal Module With Throttle Position Sensors, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
- Tightening specification, refer to ACCELERATOR PEDAL MODULE OVERVIEW .
Install in reverse order of removal. Note the following:
-- Install the driver side lower instrument panel cover, refer to INSTRUMENT PANEL COVERS ON DRIVER SIDE OVERVIEW .
-- Perform after the first kick-down adaptation in "Guided Functions", refer to Vehicle Diagnostic Tester.
NOTE:
An adaptation may need to be performed after replacing, depending on the engine/transmission combination.
If there is a menu option in "Guided Functions", perform an adaptation, refer to Vehicle Diagnostic Tester.