ATF Pan, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal. Note the following:
Tightening specifications. Refer to OIL PAN, OIL STRAINER AND MECHATRONIC, ASSEMBLY OVERVIEW .
-- Clean all magnets in oil pan recesses.
NOTE:
Make sure that the magnets are in full contact with the oil pan.
Replace the seal.
Replace the drain plug.
-- Clean the sealing surface from all sealant residue.
- The sealing surfaces must be dry and free of grease.
-- Install the oil pan with new seal.
-- Tighten the oil pan bolts in stages and in sequence -1 to 13-.
-- Install the new drain plug.
-- Fill the ATF and check the level after installing. Refer to ATF, DRAINING OR FILLING AFTER REPAIR .