Selector Lever Cable, Assembly Overview: Notes

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Selector Lever Cable Overview

Courtesy of AUDI OF AMERICA, LLC

Selector Lever Cable
- Do not bend
- SELECTOR LEVER CABLE, REMOVING AND INSTALLING
- in case of damaged rubber boot, selector lever cable must be replaced
- Ball socket and ball head must be free of oil and grease
- check whether selector lever cable rubber boot is engaged in selector mechanism shift unit and is sealed properly
- SELECTOR LEVER CABLE, ADJUSTING
Clip
- for the selector lever cable on the selector mechanism function unit
- Always replace
Screw
- 13 Nm
- For adjusting the selector lever cable
Selector Lever Cable Bolts
- The plastic retaining spring on adjustment slide must lock the pins so that they cannot fall out.
Adjustment Slide
Selector shaft lever
- Ball socket and ball head must be free of oil and grease
- SELECTOR SHAFT LEVER, REMOVING AND INSTALLING
Bracket
- For selector lever cable
Screw
- 10 Nm
- Attaching bracket to transmission
Clip
- for selector lever cable to bracket
- Always replace
Screw
- 10 Nm
- Attaching bracket to transmission