Selector Shaft Lever, Removing And Installing

Special tools and workshop equipment required 

• Pry lever80-200
  Fig 1: 80-200 Pry Lever

  Courtesy of AUDI OF AMERICA, LLC

Removing:

-- Remove screws and remove rear noise insulation -2-.

Fig 2: Identifying Front/Rear Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

-- Remove the ball head -2- on the selector lever cable from the selector shaft lever using the pry lever80-200.

Fig 3: Identifying Locking Washer & Selector Lever Cable

Courtesy of AUDI OF AMERICA, LLC

-- Remove the spring pin -1- on the selector shaft lever -2- -arrow- until it is possible to remove the lever from the shaft.

Fig 4: Driving Out Spring Dowel Sleeve At Lever/Shift Rod Of Travel Toward Front

Courtesy of AUDI OF AMERICA, LLC

Installing

Install in reverse order of removal. Note the following:

-- Install the spring pin on the selector shaft lever while it is still removed.

-- Slide selector shaft lever onto selector shaft, align it and then install the spring pin.

-- Carefully install the selector lever cable -2- to the selector shaft lever without bending the lever.

Fig 5: Identifying Locking Washer & Selector Lever Cable

Courtesy of AUDI OF AMERICA, LLC