Pistons, Removing And Installing: Removing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, and 2013 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Engine is secured to the Engine and Gearbox BracketVAS6095A. Refer to ENGINE, SECURING ON ENGINE AND TRANSMISSION HOLDER .

-- Remove the cylinder head. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .

-- Remove the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

-- Mark the installed position and to which connecting rod bearing cap and cylinder and the connecting rod it belongs for installing again later. Refer to Figure.

-- Remove the connecting rod bearing cap.

-- Remove the piston and connecting rod upward.

NOTE:

Warm the piston to approximately 60 °C (140 °F) if it is difficult to move the piston pin.

-- Remove the locking ring from the eye of the piston pin.

-- Remove the piston pin using the Pilot DriftVW222A.