Sealing Flange, Removing And Installing, Belt Pulley Side: Installing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, and 2013 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specifications

Refer to OVERVIEW - SHAFT SEAL AND SEALING FLANGE, PULLEY SIDE .
Refer to Figure.

NOTE:

Replace the seal and the shaft seal for the crankshaft.

Secure all hose connections with standard production hose clamps.

-- Clean the sealing surfaces; they must be free of oil and grease.

-- Tighten pulley side sealing flange bolts. Refer to Figure.

The rest of the installation is performed in reverse order of removal, noting the following:

-- Install the crankshaft shaft seal on the belt pulley side Refer to CRANKSHAFT SHAFT SEAL, BELT PULLEY SIDE, REPLACING .

-- Install the ribbed belt idler roller. Refer to OVERVIEW - RIBBED BELT DRIVE .

-- Install the coolant pump ribbed belt pulley. Refer to OVERVIEW - COOLANT PUMP .

-- Install oil dipstick guide tube. Refer to OIL PAN UPPER SECTION .

-- Install the oil filter element.

-- Install front coolant pipe. Refer to FRONT COOLANT PIPE ON ENGINE, REMOVING AND INSTALLING .

-- Install the ribbed belt tensioner. Refer to RIBBED BELT TENSIONER, REMOVING AND INSTALLING .

-- Install the exhaust gas recirculation cooler. Refer to EXHAUST GAS RECIRCULATION (EGR) COOLER, REMOVING AND INSTALLING .

-- Install the vibration damper. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .

-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING .