Valve Body, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

-- Attach valve body without force.

-- Tighten the valve body screws. Refer to Figure.

-- Install the bolt -arrow- for the Transmission Fluid Temperature Sensor -G93-.

Fig 1: Identifying Transmission Fluid Temperature Sensor G93

Courtesy of AUDI OF AMERICA, LLC

-- Attach connectors as far as stop.

Connectors must engage.

-- Install the oil screen. Refer to OIL SCREEN, REMOVING AND INSTALLING .

-- Install the oil pan. Refer to ATF PAN, REMOVING AND INSTALLING .

-- Fill with ATF. Refer to FILLING ATF .

If the valve body was replaced:

-- Perform a transmission adaptation. Refer to TRANSMISSION ADAPTATION .