LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2009 >> Q7 4.2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Controls & Housing - Transfer Case 0BU, Front Final Drive 0BM, 0C1 And 0BN, Rear Final Drive 0BP) >> 34 Controls, Housing >> Transfer Case Shaft Seals >> Input Shaft Seal, Removing And Installing >> Installing

Input Shaft Seal, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Installation Of Shaft Seal With Thrust Piece T10448
GWWA34-10874Courtesy of AUDI OF AMERICA, LLC

-- Lightly coat the outer circumference of the new shaft seal with oil.

-- Fill the space between the sealing- and dust lip half way with Sealing GreaseG 052 128 A1.

-- Drive in new shaft seal as far as stop without tilting it.

-- Install the transfer case. Refer to TRANSFER CASE, REMOVING AND INSTALLING .

-- Check the transmission fluid level in the transfer case. Refer to TRANSFER CASE, CHECKING TRANSMISSION FLUID LEVEL .

scientia non olet · About LEMON Manuals