Transfer Case, Checking Transmission Fluid Level
WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Shop Crane - Drip TrayVAS 6208
Procedure
NOTE:
General Repair Instructions. Refer to GENERAL REPAIR INFORMATION .
When checking oil level, vehicle must be on a level surface.
-- Place the Shop Crane - Drip TrayVAS 6208 under the transfer case.
-- Remove the transmission fluid filler plug -1-.
- The level is correct when the transfer case is filled up to the bottom edge of oil filler hole -1-.
-- Fill the transmission fluid if necessary.
Refer to TRANSFER CASE, CHECKING TRANSMISSION FLUID LEVEL .
| Component | Nm |
|---|---|
| Oil filler screw on transfer case | 20 |
|
|