LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2009 >> Q7 4.2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (3.0L - Exhaust System & Emission Controls - Engine Code: CNRB) >> 26 Exhaust System, Emission Controls >> Reducing Agent Metering System >> Reducing Agent Metering System Control Module -J880-, REMOVING AND INSTALLING >> Installing

Reducing Agent Metering System Control Module -J880-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, and 2013 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

-- After replacing, the Reducing Agent Metering System Control Module -J880- must be parameterized. Refer to Guided Functions  using the Vehicle Diagnostic Tester.

-- Install the right rear entry lamp. Refer to DOOR WARNING LAMP AND REAR ENTRY LAMP, REMOVING AND INSTALLING .

-- Install the right rear single seat in the second row of seats. Refer to Seat Frames .

-- Connect the battery and complete the steps required after connecting the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .

scientia non olet · About LEMON Manuals