EGR Motor -V338-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, and 2013 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the intake manifold. Refer to INTAKE MANIFOLD OVERVIEW .

-- Disconnect the connector -1-.

Fig 1: Identifying Connector

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Pay attention to the installed position of the EGR Motor -V338-.

-- Remove the bolts -arrows-.

Fig 2: Locating Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Free up the coolant line and the fuel line.

-- Press the coolant line and the fuel line back and then remove the EGR Motor -V338- from the Exhaust Gas Recirculation (EGR) cooler.