Intake Manifold Overview
WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, and 2013 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Bracket
- For the air guide pipe
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Gasket
- Check and replace if damaged
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Intake Flap Motor -V157-
- Removing and installing, refer to Intake Flap Motor -V157-
- Gasket
- Check and replace if damaged
- Intake Manifold
- Removing and installing, refer to INTAKE MANIFOLD
- Bolt
- Tightening specification and sequence, refer to Fig 2
- Mounting Pins
- 5 Nm
- For engine cover
- Bracket
- For the electrical connector
- Bolt
- 4 Nm
- Wiring Guide
- Bolt
- 4 Nm
- Gaskets
- Replace
- Bracket
- For Exhaust Gas Recirculation Cooler Switch-Over Valve -N345-
- Bolt
- 9 Nm
- Mounting Pins
- 5 Nm
- For engine cover
- Air Guide Pipe
- Bolt
- 9 Nm
- Gasket
- Check and replace if damaged
- Screw Clamp
- Tightening specification, refer to Special Tools
- Air Guide Hose
- Throttle Valve Control Module -J338-
- Removing and installing, refer to Throttle Valve Control Module -J338-
- Gasket
- Replace
- Pipe
- For Exhaust Gas Recirculation (EGR) system
- Bolt
- 9 Nm
- Pipe
- For EGR system
- Gasket
- Replace
- Screw Clamp
- Tightening specification, refer to Special Tools
-- Tighten bolts in 3 stages as follows:
| Stage | Bolts | Tightening Specification |
|---|---|---|
| 1. | -1 through 4- and -arrows- | Install all the way in by hand. |
| 2. | -1 ••• 4- | 5 Nm in sequence shown |
| 3. | -Arrows- | 9 Nm in any sequence |