Right Flange Shaft Dust Cap, Replacing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Subframe Bushing Tool Kit3301
Thrust Piece3456
Separating ToolKukko 17-2

Flange shaft removed. Refer to RIGHT FLANGE SHAFT SEAL, REPLACING .

Procedure

Fig 1: Pressing Off Dust Cap From Flange Shaft

Courtesy of AUDI OF AMERICA, LLC

-- Remove the dust cap -B- from the flange shaft.

A -

Separating ToolKukko 17-2

-- Install the new flange shaft dust cap -A- using the Thrust Piece3456 and Subframe Bushing Tool Kit - Assembly Tool 33301/3.

Fig 2: Identifying Installation Of Flange Shaft Dust Cap -A- Using Press Piece 3456 And Assembly Tool 3301/3

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Mount the Subframe Bushing Tool Kit - Assembly Tool 33301/3 so that the recess faces the dust cap -A-.