Right flange shaft seal, replacing
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Rules of cleanliness for working on automatic transmissions → Rules of cleanliness for working on automatic transmissions .
- General repair notes → Repair instructions .
Special tools, testers and auxiliary items required
- Extractor lever VW 681
- Thrust piece T10138
Removing
- Remove right flange shaft → Right flange shaft, removing and installing .
- Remove flange shaft seal.
Installing
- Coat outer edge of shaft seal with axle oil.
- Drive in new shaft seal as far as stop without tilting it.
- Installation position: The open side of the shaft seal faces transmission.
- Fill area between sealing lip and dust lip halfway with sealing grease G 052 128 A1 .
- Install right flange shaft → Right flange shaft, removing and installing .
- Checking gear oil level in front final drive → Differentiation of separate or combined oil systems .