Gear oil in front final drive, transmissions with separate oil systems, filling after repair
WARNING: This page is about a different variant/trim than selected.
Special tools, testers and auxiliary items required
- Old oil collecting and extracting device V.A.G 1782
- Safety glasses
Conditions
- Axle oil temperature approx. 20°C (room temperature) to max. 50°C.
- Vehicle level.
The transmission must be filled after the following work or repairs:
- The front final drive cover was removed and gear oil was completely drained.
→ Differentiation of separate or combined oil systems
Topping off
- Place Used Oil Collecting and Extracting Device V.A.G 1782 under right side of transmission.
NOTE:
- Observe disposal regulations.
CAUTION:
Wear eye protection.
- Remove oil inspection and filler plug - arrow -.
Axle oil specification , capacities → Capacities
- Slowly and evenly fill front final drive with axle oil over a duration of at least 5 minutes until oil escapes at the lower edge of the oil filler hole.
NOTE:
- The filling time of at least 5 minutes is necessary for the internal oil level to even out.
- Replace oil inspection and filler plug with seal.
- Install oil inspection and filler plug - arrow -.
Torque specification
| Component | Nm |
|---|---|
| Oil inspection and filler plug | 35 |