Selector mechanism cover, removing and installing
WARNING: This page is about a different variant/trim than selected.
Removing
- Remove selector lever handle → Selector lever handle, removing and installing .
- Remove front ashtray insert - 1 - by pressing knob - arrow -.
- Remove bolt - arrow - and front ashtray housing.
- Disconnect electrical connector.
- Pull center console switch trim up - arrows - and off.
- Disconnect electrical connector.
Fig 4: Releasing Retaining Hooks On Shift Mechanism And Raising Cover Up & Disconnecting Electrical Connector And Removing Cover
- Release retaining hooks - 1 - on both side of shift mechanism - arrow - and raise cover - 3 - up.
- Disconnect electrical connector - 2 - and remove cover.
Installing
Installation in reverse order of removal, note the following:
- Install front ashtray → 68 - INTERIOR EQUIPMENT .
- Install selector lever handle → Selector lever handle, removing and installing .