Dual Clutch, Removing And Installing: Installing: Notes
WARNING: This page is about a different car, the 2018 Audi A6, 2017 Audi A6, and 2016 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The Double Shaft Seal For The Input Shaft Must Always Be Replaced! Refer to INPUT SHAFT SEAL, REPLACING .
-- Check if the sleeves -1 and 2- are installed.
-- Coat the new seals -3, 4 and 5- with ATF and install.
-- Insert the seal -6-.
NOTE:
Make Sure No Dirt Can Fall Into The Transmission While Cleaning.
-- Install The Engaging Bearing With The Slave Cylinder And Tighten The Three Bolts -arrows- Evenly.
NOTE:
Depending On The Version The Three Bolts -Arrows- May Not Be Present.
NOTE:
Pay Attention That The Engaging Bearing Is Installed Correctly To The Slave Cylinder.
The Ball Bearings Are Visible! -arrow-
-- Install the :T40288 in the threaded hole approximately 120° offset.