Input Shaft Seal, Replacing: Overview
WARNING: This page is about a different car, the 2018 Audi A6, 2017 Audi A6, and 2016 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Puller - Crankshaft/Power Steering Seal :T20143
- Thrust Piece :T40300
- Clutch, engaging bearing and slave cylinder removed. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .
-- With the :T20143 carefully remove the seal -arrow- from the housing.
-- A waved washer -arrow- is located behind the seal, it does not need to be replaced.
NOTE:
Pay Attention To The Installed Position.
-- Drive in the new seal to the stop using the :T40300 .
-- Install the clutch. Refer to DUAL CLUTCH, REMOVING AND INSTALLING .