Microswitch for seatback release, assembly overview

1 - Cable tie

2 - Connector

3 - Circlip

4 - Microswitch for seatback release

• Removing 

• Remove seat → Seat, assembly overview .
• Attach fixture for seat repair VAS 6136 to engine and transmission holder VAS 6095.
• Attach front seat to fixture for seat repair VAS 6136.
• Remove door sill side seat trim → Side trim on sill panel side, removing and installing .

• Remove tunnel side seat trim → Side trim, inboard side, assembly overview .
• Remove backrest → Front seat backrest, assembly overview .
• Remove backrest panel → Backrest cover panel, removing and installing .
• Remove backrest frame → Backrest frame, assembly overview .

• Remove backrest cover and cushion → Backrest cover and padding (sports seat, standard seat), removing and installing .
• Use a screwdriver to pry out circlip - 3  -.
• Press together catches - 5  - (2x) and remove microswitch - 4  -.
• Disconnect connector - 2  -.

• Installing 

• Press in microswitch - 4  - until the catches - 5  - (2x) engage.
• Connect connector - 2  -.
• Install backrest cover and cushion g → Backrest cover and padding (sports seat, standard seat), removing and installing .
• Install backrest → Front seat backrest, assembly overview .

• Install seat → Seat, assembly overview .
• Adjust microswitch for seatback release → Microswitch for seatback release, adjusting .
• Insert the circlip - 3  -.
• Install backrest frame → Backrest frame, assembly overview .

• Install backrest panel → Backrest cover panel, removing and installing .

5 - Catches (2x)