LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2008 >> TT Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 56 (2.0L - Turbocharger, Supercharger - Engine Code(S): BPY (Coupe) (As Of 10.2010)) >> Turbocharger, Supercharger >> Specifications >> Fastener Tightening Specifications

Fastener Tightening Specifications

WARNING: This page is about a different variant/trim than selected.
Component Bolt Size Nm
Bracket for Wastegate Bypass Regulator Valve - 7
Bracket to Turbocharger6 - 30
Bracket to Turbocharger7 - 23
Charge Air Pressure Sensor - 5
Charge Air Pipe - 10
Connection - 9
Coolant Supply Line2
  - 23
  - 35
Coolant Return Line
  - 9
  - 35
Fastening Strip, Nut5 - 30
Heat Shield - 9
Mount for Charge Air Cooler - 5
Nipple - 8
Oil Return Line - 9
Oil Supply Line1
  - 9
  - 30
Oil Supply Line to Oil Filter Bracket - 25
Right Charge Air Pipe to Oil Pan - 10
Rear Charge Air Tube to Bracket - 10
Turbocharger, Nut3, 5 - 21
Turbocharger Recirculating Valve - 7
Turbocharger Vacuum Diaphragm
-Nut8 - 9
-Bolt - 10
Wastegate Bypass Regulator Valve - 3
  • 1 For bolt tightening clarification, refer to PART II  and see items -2, 5 and 6-
  • 2 For bolt tightening clarification, refer to Part II  and see items -8, 11 and 12-
  • 3 Always replace
  • 4 For bolt tightening clarification, refer to PART III  and see items -3 and 5-
  • 5 Coat stud bolts on exhaust manifold with hot bolt paste.
  • 6 For bolt tightening clarification, refer to PART III  and see items -8-
  • 7 For bolt tightening clarification, refer to PART III  and see items -11-
  • 8 Secure with sealing wax
scientia non olet · About LEMON Manuals