Central Tube Angled Bracket, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Observe the following when doing so:

-- Align the central tube angle bracket according to the markings applied on the A-pillars during removal.

-- When installing a new angle bracket, remove centering pin -3- if necessary after installing instrument panel central tube.

NOTE:

If the angle bracket is attached after replacement of the A-pillar and there is no installation mark, transfer the installation dimensions of the angle bracket to the opposite side.

-- Install instrument panel central tube. Refer to INSTRUMENT PANEL CENTRAL TUBE, REMOVING AND INSTALLING .

Tightening specifications. Refer to INSTRUMENT PANEL CENTRAL TUBE OVERVIEW .