LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2008 >> A5 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1374 (Passenger Protection, Airbags, Seat Belts (Cabriolet)) >> 69 Passenger Protection, Airbags, Seat Belts >> Rollover Protection >> Rollover Support Guide, Removing And Installing >> Installing

Rollover Support Guide, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Follow the safety precautions for the rollover protection. Refer to ROLLOVER PROTECTION .

Install in reverse order of removal and Note The Following: 

-- Press the rollover support guide on until it engages audibly.

-- Retract an extended rollover support. Refer to EXTENDED ROLLOVER SUPPORT, RETRACTING .

WARNING:

Make sure no one is standing near the rollover protection when reconnecting the battery. Stand at least one meter away.

-- Connect the battery ground cable. Refer to BATTERY .

-- ALWAYS perform an output diagnostic test under "Guided Functions" on the Vehicle Diagnostic Tester after repairing the rollover protection and only after all work procedures are completed (also if new rollover protection was installed).

scientia non olet · About LEMON Manuals