Headlamps with High Intensity Gas Discharge (HID) "Bi-Xenon" Lamps, assembly
NOTE:
- After performing any repairs or service that could affect headlight aim, check/adjust aim.
1 - Trim cover
2 - Headlamp housing
- Removing and installing → Headlamps, removing and installing
3 - Turn signal/parking lamp bulb
- 12 V, 28/7 W
- Orange
- Replacing → Turn signal/parking lamp bulb, replacing
4 - Bulb holder
- For turn signal
5 - Headlamp beam adjustment motor
- Left Headlamp Beam Adjustment Motor V48
- Right Headlamp Beam Adjustment Motor V49
- Removing and installing → Headlamp Beam Adjustment Motor V48 / V49, removing and installing
6 - High intensity gas discharge (HID) low beam headlamp bulb
- 35 W, D1S
- Replacing → HID low beam headlamp bulb, replacing
7 - Screw - 1.5 Nm
8 - Adapter lead
- Removing and installing → Adapter cable for HID headlamp bulb control module, removing and installing
9 - High intensity gas discharge (HID) lamp control module
- Left High-intensity Gas Discharge (HID) Lamp Control Module J343
- Right High-intensity Gas Discharge (HID) Lamp Control Module J344
- Removing and installing → High Intensity Gas Discharge (HID) Lamp Control Module J343 / J344, removing and installing
10 - Screw - 1.5 Nm
11 - Housing cover
12 - Cover cap with adjuster wheel
13 - Screw - 1.5 Nm
14 - Adjuster rod
15 - Left High Beam Headlamp M30 , Right High Beam Headlamp M32 - bulb
- H10 - 12 V, 42 W
- Replacing → High Beam Headlamp bulb M30 / M32, replacing
16 - Vent element
- 1x
17 - Screw - 6 Nm
18 - Stop bolt
- For aligning headlamp housing with body contour
- Must make contact with lock carrier