High Beam Headlamp bulb M30 / M32, replacing
CAUTION:
- HIGH VOLTAGE!
- Always disconnect negative ( - ) battery terminal prior to working on parts of HID headlamp components marked with yellow "HIGH VOLTAGE" warning symbols.
Removing
- Remove headlamp → Headlamps, removing and installing .
- Remove screws - 1 - and - 2 -.
- Release retaining clip - 3 - in direction of - arrow - and detach housing cover from headlamp housing.
- Turn bulb - 1 - clockwise - arrow - and remove from housing.
- Disconnect electrical connection - 2 -.
Installing
Install in reverse order of removal, noting the following:
CAUTION:
- Do not touch glass portion of bulb with bare hands. Even the smallest amount of moisture and/or contaminants from fingers that evaporates on the bulb during operation can cause the glass to cloud over.
- When installing housing cover, ensure proper seating. Water intrusion will damage headlamp.
- Fit new bulb in housing.
- Secure bulb by turning in counter-clockwise direction.
- Secure housing cover with screws and retaining clip.
- Install headlamp Installing .
- Reconnect battery. Required steps Reconnecting .