Evaporative Emission (EVAP) Canister Purge Solenoid Valve N115 , removing and installing

Removing 

• Switch off ignition.
• Remove left rear wheel.

Fig 1: Identifying Hose Connectors, Evaporative Emission (EVAP) Canister Purge Solenoid Valve N115 Electrical Harness Connector & Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove left rear wheel housing liner → 66 - EXTERIOR EQUIPMENT .
• Separate hose connections - 1  - , - 3  - and - 4  -.
• Disconnect electrical harness connector - 2  - from Evaporative Emission (EVAP) Canister Purge Solenoid Valve N115.

Fig 2: Identifying Evaporative Emission (EVAP) Canister Purge Solenoid Valve N115 Vacuum Hoses & Solenoid Valve

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove vacuum hoses - 3  - and - 4  - from Evaporative Emission (EVAP) Canister Purge Solenoid Valve N115 - 2  -.
• Pull solenoid valve out of mounting - 1  -.

Installing 

• Tightening torque → Leak Detection Pump (LDP) V144 , assembly overview .

Installation is in reverse order of removal, note the following:

• Install left rear wheel housing liner → 66 - EXTERIOR EQUIPMENT .