Seat, removing and installing

Special tools, testers and auxiliary items required

Fig 1: Identifying Torque Wrench V.A.G. 1332

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Torque wrench V.A.G 1332

NOTE:

Before disconnecting battery: Obtain radio code.

Fig 2: Seat Remove/Install Components

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - Front seat

Removal:

CAUTION: Observe safety precautions for work on airbags → Airbag safety precautions .

Remove front seat rail covers → Front seat rail covers, removing and installing .
Remove rear seat rail covers → Rear seat rail covers, removing and installing .
Push front seat - 1 - fully upward and to the rear.
Remove front bolts - 2 - (2x).

Move seat forward.
Remove rear bolts - 2 - (2x).
Disconnect battery ground wire →
- 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL
- 27 - BATTERY, STARTER, GENERATOR, CRUISE CONTROL for ELECTRICAL EQUIPMENT - GENERAL INFORMATION
.

CAUTION: Before handling airbag units (e.g. disconnecting electrical connector), the person handling it must "electrostatically discharge". This can be done by touching door striker, for example.

Tip front seat - 1 - back.
Disconnect harness connectors → Disconnecting connections .
Connect airbag adapter → Airbag Adapter VAS 6036, connecting .

Installing:

Installation is reverse of removal. Observe the following when doing so:

CAUTION:

Observe safety precautions for work on airbags → Airbag safety precautions .
Before handling airbag units (e.g. disconnecting electrical connector), the person handling it must "electrostatically discharge". This can be done by touching door striker, for example.

Remove Airbag Adapter VAS 6036 only after installing front seat → Airbag Adapter VAS 6036, connecting .

NOTE:

Ensure that electrical connections are pushed in as far as stop and engage with a click.

Connect connector to couplings on connector station location in floor → Disconnecting connections .
Switch on ignition.

CAUTION: Ignition must be on when connecting battery. If pyrotechnic components (e.g. airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.

Connect battery ground wire with ignition switched on →
- 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL
- 27 - BATTERY, STARTER, GENERATOR, CRUISE CONTROL for ELECTRICAL EQUIPMENT - GENERAL INFORMATION
.
If Airbag Malfunction Indicator Lamp (MIL) K75 indicates a fault after installation, DTC memory must be checked, deleted and checked again Vehicle Diagnosis, Testing and Information System VAS 5051B.

2 - Screw

50 Nm
Qty. 4