Disconnecting connections
NOTE:
- Technician must be grounded before disconnecting ignition and ground wiring, touching door striker or body.
1 - Front seat
2 - Belt buckle sensor connector (black)
3 - Seat heating connector (green)
4 - Current supply connector (red)
5 - Airbag connector (yellow)
6 - Connector point cover
- Removal:
- Tip front seat - 1 - back.
- Remove coupling station cover - 6 - upward.
- Press in tab on airbag connector - 5 - on tunnel side and disconnect airbag connector - 5 -.
- Connect airbag adapter → Airbag Adapter VAS 6036, connecting .
- Press in tab on connector for voltage supply - 4 - on tunnel side and disconnect connector for voltage supply - 4 -.
- Press in tab on airbag connector for heated seat - 3 - on tunnel side and disconnect connector for heated seat - 3 -.
For vehicles with seatbelt fasten sensor:
- Press in tab on connector for seatbelt fasten sensor - 2 - on tunnel side and disconnect connector for seatbelt fasten sensor - 2 -.
- Installing:
Installation is reverse of removal.