Seat, removing and installing
Special tools, testers and auxiliary items required
- Torque wrench V.A.G 1332
NOTE:
- The RS sport seat has no side airbag. Therefore, the electrical connection for the side airbag must have a terminal resistance in the wiring harness.
- Depending on the version, this terminal resistance is securely connected to the wiring harness, or is designed as a separate connector housing with terminal resistance → Connector housing with terminal resistance for side airbag .
1 - Front seat
Removing
- Push front seat - 1 - fully upward and to the rear.
- Remove front bolts - 3 - (Qty. 2).
- Move seat forward.
- Loosen seatbelt eyelet at outer anchoring point for seat and remove seatbelt from belt guide.
- Remove rear bolts - 4 - (Qty. 2).
- Tip front seat - 1 - back.
- Disconnect electrical harness connectors → Electrical harness connectors, disconnecting .
Installing
Installation is reverse of removal.
2 - Seat rail covers
- Right front and left rear are identical
- Left front and right rear are identical
- Removing and installing → Seat rail cover, removing and installing
3 - Front bolts (2x)
- Tightening torque 50 Nm
4 - Rear bolts (2x)
- Tightening torque 50 Nm