Electrical harness connectors, disconnecting

1 - Connector point cover

Removing 

• Remove seat → Seat, removing and installing .
• Tip front seat - 2  - back.
• Remove coupling station cover - 1  - upward.
• Press in tab on connector for voltage supply - 5  - on tunnel side and disconnect connector for voltage supply.

• Press in tab on connector for heated seat - 4  - on tunnel side and disconnect connector for heated seat.

For vehicles with seatbelt fasten sensor:

• Press in tab on connector for seatbelt fasten sensor - 3  - on tunnel side and disconnect connector for seatbelt fasten sensor.

Installing 

Installation is reverse of removal.

2 - Front seat

3 - Belt buckle sensor connector (black)

• Depending on version

4 - Seat heating connector (green)

5 - Current supply connector (red)

6 - Connector housing with terminal resistance for side airbag

• Depending on the version, this terminal resistance is securely connected to the wiring harness, or is designed as a separate connector housing with terminal resistance.
• Installation location → Connector housing with terminal resistance for side airbag