Overview - Coolant Pump And Thermostat
WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 9 Nm
- Bolt
- 20 Nm
- Coolant Pump Ribbed Belt Pulley
- Coolant Pump
- With seal
- Removing and installing. Refer to COOLANT PUMP, REMOVING AND INSTALLING
- Bolt
- 9 Nm
- Bolt
- Tightening specification -item 2- OVERVIEW - SUPERCHARGER RIBBED BELT DRIVE .
- Washer
- Idler Roller for Ribbed Belt
- Connecting Piece
- For coolant hose
- Seal
- Replace
- Seal
- Coolant Thermostat
- Removing and installing. Refer to COOLANT THERMOSTAT, REMOVING AND INSTALLING
- Checking. Refer to COOLANT THERMOSTAT, CHECKING NOTE:
When removing and installing the coolant thermostat, make sure that the thermostat needle is installed correctly (conical end is inserted in the coolant thermostat wax thermostatic element). If necessary, push the thermostat needle all the way into the wax thermostatic element.
- Bolt
- 9 Nm