Overview - Supercharger Ribbed Belt Drive
WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Ribbed Belt
- For the supercharger
- Check for wear
- Removing and installing. SUPERCHARGER RIBBED BELT, REMOVING AND INSTALLING
- When installing, make sure it is seated correctly on the ribbed belt pulleys
- Bolt
- 40 Nm
- Washer
- Cover
- Supercharger
- Overview. Refer to OVERVIEW - SUPERCHARGER
- Idler Roller
- For the ribbed belt
- Vibration Damper
- With ribbed belt pulley
- Installation is only possible in one position because of the offset holes
- Removing and installing. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING
- Bolt
- Tightening specification: 20 Nm + 90° turn.
- Tensioner
- For the ribbed belt
- Removing and installing. Refer to SUPERCHARGER RIBBED BELT TENSIONER, REMOVING AND INSTALLING
- Bolt
- 40 Nm