Overview - Supercharger
WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Engine Lifting Eye
- Bolt
- Tightening specification: 27 Nm
- Supercharger
- With charge air coolers
- Supercharger, removing and installing. Refer to SUPERCHARGER, REMOVING AND INSTALLING .
- Charge air cooler assembly overview. Refer to OVERVIEW - CHARGE AIR COOLER .
- Secure for work on the Engine And Transmission Holder VAS 6095. Refer to SUPERCHARGER, SECURING TO ENGINE/TRANSMISSION HOLDER .
- Secure for leak test on the Engine And Transmission Holder VAS 6095. Refer to SUPERCHARGER, SECURING TO ENGINE/TRANSMISSION HOLDER FOR LEAKAGE TEST .
- Insulation Plate
- Bolt
- Tightening specification: 5 Nm
- Rubber Grommet
- Quantity: 2
- Intermediate Flange
- Bolt
- Tightening specification. Refer to Special Tools .
- Throttle Valve Control Module -J338-
- Removing and installing. Refer to Throttle Valve Control Module -J338-, REMOVING AND INSTALLING .
- O-Rings
- Replace
- Connection
- Bolt
- Tightening specification and sequence. Refer to Special Tools .
- Bracket
- for change-over valves
- Bolt
- Tightening specification: 9 Nm
- Bolt
- Tightening specification and sequence. Refer to Special Tools .
- Intermediate Flange
- Control Valve Control Unit -J808-
- Removing and installing. Refer to Control Valve Control Unit -J808-, REMOVING AND INSTALLING .
- Bleeder Screw
- For the left charge air cooler
- 1.5 to 3.0 Nm.
- Bolt
- Tightening specification. Refer to Special Tools
- Intake Air Temperature Sensor -G42- /Manifold Absolute Pressure Sensor -G71-
- Removing and installing. Refer to Intake Air Temperature Sensor -G42- /Manifold Absolute Pressure Sensor -G71-, REMOVING AND INSTALLING .
- O-Rings
- Replace
- Nut
- Tightening specification: 20 Nm
- O-Ring
- Replace
- Threaded Pin
- Tightening specification: 17 Nm
- Bolt
- Tightening specification: 10 Nm
- Replace
- Self-locking
- Always clean the threaded holes with a thread tap before assembling
- Charge Air Pressure Sensor
- Cylinder bank 1 (right) Charge Air Pressure Sensor -G31-
- Cylinder bank 2 (left) Charge Air Pressure Sensor 2 -G447-
- Removing and installing. Refer to Charge Air Pressure Sensor -G31- / Charge Air Pressure Sensor 2 -G447-, REMOVING AND INSTALLING
- Seals
- Replace
- O-Ring
- Quantity 2
- Replace
- Connecting Piece
- For the crankcase ventilation
- Installed position. Refer to Fig 2
- O-Ring
- Quantity 2
- Replace