Self-Leveling Suspension Control Position, Programming

Special tools and workshop equipment required

Vehicle Diagnosis, Testing and Information System VAS5051A

-- Connect VAS5051A and then perform vehicle-specific entry into Guided Fault Finding and select Go To button "function/component selection". Refer to VAS5051 CONNECTING AND SELECTION FUNCTIONS .

Then

-- "Chassis (Repair group 01; 40 - 49)"

-- "34 - Level control (Repair group 01: 43, 44)".

-- "01 - On Board Diagnostic (OBD) capable systems"

-- "J197 - Level control system control module functions".

-- "J197 - Adapting control position".

NOTE:

If the control position was programmed on vehicles with lane assist, the directional stabilization assistance control module -J759- with integrated camera must be calibrated. Refer to LANE ASSIST CALIBRATION PROCEDURE .