Fuel tank with attachments, assembly overview: Notes
NOTE:
- The fuel system shown in illustration is for vehicles with 6-cyl. engine.
1 - Fuel supply line
- From fuel filter
- To engine
- Do not kink
- To disconnect, press release button on connection piece
2 - Fuel return line
- From engine
- Do not kink
- To disconnect, press release button on connection piece
- Clipped in on fuel tank
3 - Ventilation line
- From EVAP canister to Evaporative Emission (EVAP) Canister Purge Regulator Valve N80
- Do not kink
- To disconnect, press release button on connection piece
- Clipped in on fuel tank
4 - Electrical harness connector
- For Fuel Tank Lock Switch F314
- Checking electrical → Fuel Tank Lock Switch F314 , checking
5 - 23 Nm
6 - Overflow hose
- Engage in wheelhousing
7 - Rubber gasket
8 - Circlip
9 - Oil seal
- Replace if damaged
10 - Filler cap
11 - Ground (GND) connection
- For discharging electrostatic charge
- Installed position/check requirements Installation position of Ground (GND) connection
- After installing, check electrical connection of metal ring at fuel filler tube to a bare area of chassis using Ohm meter - Specified value: approx. 0Ω
12 - Ventilation line
13 - Ventilation line
- From gravity valve to EVAP canister
- To remove, press release ring on EVAP canister
14 - Ventilation line
- From EVAP canister to Evaporative Emission (EVAP) Canister Purge Regulator Valve N80
- To remove, press release ring on EVAP canister
- Clipped in on fuel tank
15 - Fuel tank
- Removing and installing → Fuel tank with attachments, removing and installing
16 - Heat shield
- For fuel tank
17 - 2 Nm
18 - Heat shield
- For fuel tank
19 - 2 Nm
20 - Spreader clip
21 - Securing strap
- Note different lengths
22 - 23 Nm