Fuel Tank Lock Switch F314 , checking
The Fuel Tank Lock Switch F314 consists of a reed contact on fuel filler tube and a fuel tank cap with an embedded magnet. If fuel tank cap is not fully screwed on, the reed contact switches on an indicator in the instrument cluster.
Special tools, testers and auxiliary items required
- Portable multimeter V.A.G 1526 B
- Connector test set V.A.G 1594 C
Test sequence
- If indicator is lit, check the following points in order:
- Fuel tank cap is completely screwed on.
- Correct fuel tank cap (Identification: Threads are gray in color).
- Switch - arrow - at fuel filler tube is fully inserted.
- Electrical switch is faulty.
- Wiring connection to instrument cluster is faulty (check according to schematics).
Fuel Tank Lock Switch F314 , checking electrical
Sedan:
- Remove carpeting in luggage compartment.
- Fold forward right rear seat backrest, if necessary.
Wagon:
- Remove left 1/3 backrest →
- 72 - SEAT - FRAMES
- 72 - SEAT - FRAMES for BODY INTERIOR - CABRIOLET
- Remove left side luggage compartment trim and dirt tray →
- 70 - INTERIOR TRIM
- 70 - INTERIOR TRIM for BODY INTERIOR - CABRIOLET
All models:
- Unbolt locking flange cover in luggage compartment - arrows -.
- Disconnect electrical connector - 2 -.
NOTE:
- Ignore - 1 -.
- Connect hand multimeter V.A.G 1526 B between terminal - 1 - and - 2 - for resistance measurement.
| Fuel tank cap | Specified value |
|---|---|
| Screwed on tight | ∞ Ω |
| Not or incorrectly screwed on | Less than 1 Ω |
If specifications are not obtained:
- Remove right rear wheel housing liner →
- 66 EXTERIOR EQUIPMENT
- 66 - EXTERIOR EQUIPMENT for BODY EXTERIOR - CABRIOLET
- Replace Fuel Tank Lock Switch F314 - arrow - , by unclipping and clipping in switch and electrical wiring at fuel filler tube.