Bowden cable of seat height adjuster unit, removing and installing

1 - Bowden cable of seat height adjuster unit

• Removing 

• Remove seat → Seat, assembly overview .
• Attach fixture for seat repair VAS 6136 to engine and transmission holder VAS 6095.
• Attach front seat to fixture for seat repair VAS 6136.
• Remove side trim on sill panel side → Side trim on sill panel side, removing and installing .

• Remove side trim on tunnel side → Side trim on tunnel side, removing and installing .
• Remove backrest → Front seat backrest, assembly overview .
• Remove Bowden cable - 1  - from holder - 2  -.
• Remove tab - 4  - from pin - 3  -.

• Remove Bowden cable - 1  - from holder - 5  -.
• Remove Bowden cable at hook - 7  - from holder - 6  -.

• Installing 

• Install Bowden cable of seat height adjuster unit - 1  - in reverse order of removal.

2 - Holder

3 - Pin

4 - Tab

5 - Holder

6 - Holder

7 - Hook