Microswitch for seatback release, adjusting
NOTE:
- For vehicles up to 05.02, VIN: 8H 3K 002 450: To prevent malfunctions of headrest and seatback adjustment, apply a cable tie - 1 -.
1 - Cable tie
2 - Connector
3 - Circlip
4 - Microswitch for seatback release
- Adjusting and checking function
- Remove backrest panel → Backrest cover panel, removing and installing .
- Use a screwdriver to pry out circlip - 3 -.
- Slide microswitch - 4 - only far enough so that backrest is switched off when release lever is lifted 1/3.
- Check backrest function at adjustment switch:
- Backrest is not activated when backrest release lever is lifted to 1/3.
- Backrest is activated when release lever is in rest position.
- Correct the position of microswitch - 4 - as necessary and check its function again.
5 - Catches (2x)