Turbocharger Overview: Notes

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 Audi A3, 2012 Audi A3, 2011 Audi A3, 2010 Audi A3, and 2009 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Secure all hose connections using hose clamps appropriate for the model type.

Hose connections and charge air system hoses must be free of oil and grease before installing. On connector couplings, the seal and sealing surfaces must only be lightly oiled. Refer to HOSE CONNECTIONS WITH CONNECTOR COUPLINGS, ASSEMBLING .

Charge air system must be properly sealed.

Replace the self-locking nuts.

Hose clip pliers VAS 6362 or hose clip pliers V.A.G 1921 are recommended for installing spring clamps.

Add oil to turbocharger through oil feed line connecting piece.

After installing turbocharger, let engine idle for approximately 1 minute without increasing engine speed. This ensures adequate oil supply to the turbocharger.

Observe the rules for cleanliness. Refer to CLEAN WORKING CONDITIONS .