Charge Air Cooler Overview
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 Audi A3, 2012 Audi A3, 2011 Audi A3, 2010 Audi A3, and 2009 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- The hose supports, air guide pipes and hoses must be free of oil and grease before installing.
- To mount the charge hoses on their connectors securely, spray the bolts on the used clamps with rust remover before installing.
- Secure all hose connections with hose clamps of the same type as those equipped by the factory.
- If there are small impressions on the fins.
- Bolt
- 5 Nm
- Bearings
- For the charge air cooler
- Charge Air Cooler
- Charge Air Pipe
- Assembly of hose connections with connection couplings, refer to HOSE CONNECTIONS WITH CONNECTOR COUPLINGS, ASSEMBLING
- Bolt
- 10 Nm
- Charge Air Hose
- Assembly of hose connections with connection couplings, refer to HOSE CONNECTIONS WITH CONNECTOR COUPLINGS, ASSEMBLING
- Clamp
- Charge Air Hose
- To the throttle valve control module -J338
- Clamp
- Bolt
- 10 Nm
- Charge Air Pipe
- Clamp
- Charge Air Hose
- Assembly of hose connections with connection couplings, refer to HOSE CONNECTIONS WITH CONNECTOR COUPLINGS, ASSEMBLING
- Seal
- Replace
- Charge Air Pressure Sensor -G31
- Removing and installing, refer to CHARGE AIR PRESSURE SENSOR -G31
- Bolt
- 5 Nm
- Bolts
- 10 Nm