Secondary Air Injection (AIR), assembly overview: Notes
WARNING: This page is about a different variant/trim than selected.
1 - Right combination valve for Secondary Air Injection (AIR)
- Location: Right front on engine
- Checking → Combination valve for secondary air injection, checking function and for proper seal
- Removing and installing → Right combination valve for secondary air injection, removing and installing
2 - Secondary Air Injection (AIR) pump relay J299
3 - Engine Control Module (ECM) 2 J624
- Location: Next to electronics box on right
4 - Engine Control Module (ECM) J623
- Location: Above electronics box on left
5 - Secondary Air Injection (AIR) pump relay 2 J545
6 - Left combination valve for Secondary Air Injection (AIR)
- Location: Left front on engine
- Checking → Combination valve for secondary air injection, checking function and for proper seal
- Removing and installing → Left combination valve for Secondary Air Injection (AIR), removing and installing
7 - Secondary Air Injection (AIR) pump motor 2 V189
- For cylinder bank 2 (left)
- Location → Location of Secondary Air Injection (AIR) pump motor V101 and Secondary Air Injection (AIR) pump motor 2 V189
- Removing and installing → Secondary Air Injection (AIR) pumps, removing and installing
8 - Secondary Air Injection (AIR) pump motor V101
- For cylinder bank 1 (right)
- Location → Location of Secondary Air Injection (AIR) pump motor V101 and Secondary Air Injection (AIR) pump motor 2 V189
- Removing and installing → Secondary Air Injection (AIR) pumps, removing and installing